Plug n’ Play engine harness for Holley EFI and most GM-based engines.
HCR Innovations has considered all of the complaints and downfalls of the other harnesses on the market, fixed them and made the best plug and play option out there.
Here are some highlights:
- Dual can bus plugs (so no need to buy a can bus splitter).
- Built in dual relay/fuse box.
- Proper sized power and ground feeds built into the harness for all coils and even those big boy injectors. (Dual 14-gauge feeds for the injector sub harness, 1 12-gauge power and ground feed per bank of coils) so crank up the dwell and buy those big boy m1 injectors without fear.
- Extended length o2 sensor lead with an early break out for routing independently from rest of engine harness.
- A single branch point in the harness allows you to route wiring however you want to fit YOUR setup.
- Gt150 style connector for map sensor (screw in body, pressure transducer style for map sensors).
- The whole harness is covered in a solid loom, not split loom.
- All branches are sealed off with adhesive lined heat shrink, not electrical tape.
- All splices in the harness are done with an ultrasonic welder for the highest quality, lowest profile, most durable way to splice multiple wires together.
- All labels are printed on black adhesive lined heat shrink and then covered with clear heat shrink (these aren’t falling off).
- Every single harness is tested on a cirrus hi pot tester, so no more fears of working with mislabeled, mispinned and poorly crimped harnesses.
All harness kits come with an instruction manual, but once you put this in your hand, you’ll understand how easy the install can really be.
Designed, tested and manufactured in America by Americans!
For some more in-depth information check out our video!
John Woods (verified owner) –
The Craftsmanship on this harness is top notch. Far exceeded my expectations. You get what you pay for, especially these days and the quality is there. It’s worth every penny. Again, made in America, by American’s and it shows. I needed a little extra done to the harness, made a phone call… done. Would highly recommend.
John Kettles (verified owner) –
Got my harness today. I have not installed it yet. But laid it out to start. The craftsmanship and quality amazing! Thank you HCR this will ne the nicest part of my truck’s wiring.